JVC KA-MR100G Service Manual page 12

5.1.4 Install the Internal cable
(1) Remove the four screws.
(2) Pass 12P cable through under the PS PWB.
(3) Connect Gray 6P cable connector to SW PWB CN54.
Gray 6P cable connector
Remote PWB CN87
Note.
Gray 6P cable should be wired at back of the
cable of Remote PWB CN87 in order to prevent
from touching fan motor.
(4) Connect Blue 6P cable connector to DV OUT CN54.
Note.
The cable should be passed through this
position of figure.
1-12 (No.HC027<Rev.001>)
Fig.8
12P cable connector
Fig.9
Fig.10
Fig.11
5.1.5 Install the KA-UM100G
(1) Reinstall the PS PWB cover and tighten four screws.
(2) Connect Battery cable and Battery INFO cable.
Note.
The connector should be placed to the
bottom space.
(3) Connect 12P cable connecter to KA-UM100G.
Note.
Connect 12P cable connecter
firmly by using tweezers etc.
Note.
The cable should be placed in the groove
space of KA-UM100G.
Fig.12
Fig.13
Fig.14
Fig.15