Table of Contents
Advertisement
RX-V595/R-V905/RX-V595RDS
TO SERVICE PERSONNEL
1. Critical Components information.
Components having special characteristics are marked and must be
replaced with parts having specifications equal to those originally
installed.
2. Leakage Current Measurement (For 120V Model only).
When service has been completed, it is imperative that you verify that
all exposed conductive surfaces are properly insulated from supply
circuits.
•
Meter impedance should be equivalent to 1500 ohm shunted by 0.15µF.
•
Leakage current must not exceed 0.5mA.
•
Be sure to test for leakage with the AC plug in both polarities.
"CAUTION"
"F804: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE,REPLACE ONLY WITH SAME TYPE 8.0A, 250V FUSE."
CAUTION
F804: REPLACE WITH SAME TYPE 8.0A, 250V FUSE.
A
V
ATTENTION
F804: UTILISER UN FUSIBLE DE RECHANGE DE MEME TYPE DE 8.0A, 250V FUSE.
WARNING: CHEMICAL CONTENT NOTICE!
The solder used in the production of this product contains LEAD. In addition, other electrical/electronic and/or plastic (where
applicable) components may also contain traces of chemicals found by the California Health and Welfare Agency (and possibly
other entities) to cause cancer and/or birth defects or other reproductive harm.
DO NOT PLACE SOLDER, ELECTRICAL/ELECTRONIC OR PLASTIC COMPONENTS IN YOUR MOUTH FOR ANY REASON
WHATSOEVER!
Avoid prolonged, unprotected contact between solder and your skin! When soldering, do not inhale solder fumes or expose eyes
to solder/flux vapor!
If you come in contact with solder or components located inside the enclosure of this product, wash your hands before handling
food.
REMOTE CONTROL PANELS
U,C,R,T and L models
1
WALL
OUTLET
ˆ
A,B and G models
AC LEAKAGE
EQUIPMENT
TESTER OR
UNDER TEST
EQUIVALENT
INSULATING
TABLE
Hide quick links:
Advertisement
Table of Contents
