UltraCOOL CP35 Use & Care Manual page 3

2.
A gauge on the front of the unit shows the water level. When the reservoir is full,
the window will show a full blue fill. When
the reservoir is low, an indication of LOW
WATER will appear in the window.
Observe this gauge to monitor the water
level.
OPERATIONS
Operating Instructions
When first plugged in the control panel will momentarily light up and unit will beep.
The unit is in Standby mode, and the Power button will stay illuminated in red.
With the unit filled and plugged in, press the Power button and it will change from
Red to Blue.
NOTE: For best cooling, we recommend turning on the pump 2 or 3 minutes before
turning on the fan. This allows the media to become saturated for faster cooling
effect.
NOTE: This unit can be used as a fan only or an evaporative cooler. If no evaporative cooling
is desired, simply do not engage the pump and use only the fan feature.
For Evaporative Cooling:
With the unit already filled and turned on:
1. Press the PUMP button. This will activate the pump to begin saturating the
media. The two Droplet icons will alternately flash.
2. Press the SPEED button to engage the fan. The 3-speed fan starts in High and
can be adjusted down by pressing the SPEED button again. The FAN display
shows 6 bars for High, 4 bars for Medium and 2 bars for Low.
For Fan Only Operation:
With unit turned on:
1. Press the SPEED button. The fan proceeds from High speed to Medium to Low
speed.
2. The FAN icon will be progress from 6 bars ( high speed) to four bars (medium.
speed) to 2 bars ( low speed). It will cycle in this order when pressed.
ALL ICONS SHOWN FOR REFERENCE
3