Safety Rules
1.
Unit must be in the Off Position and Unplugged from power receptacle when
performing any maintenance.
2.
To reduce the risk of electric shock, plug unit into a properly grounded 120 Volt
A.C., 60 Hz receptacle.
3.
To reduce the risk of electric shock, install only on a circuit protected with a
Ground Fault Circuit Interrupter (GFCI).
4.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
5.
Do Not operate any fan with a damaged cord or plug. Discard fan or return to an
authorized service facility for examination and/or repair.
6.
Do Not run cord under carpeting. Do Not cover cord with throw rugs, runners or
similar coverings. Do Not route cord under furniture or appliances. Arrange cord
away from traffic area and where it will not be tripped over.
WARNING: To reduce the risk of fire or electric shock, do not use this fan with
any "solid-state fan speed control device."
Assembly
Remove unit from carton, and remove packing material.
Install Casters
This unit comes with 4 stem casters:
2 locking and 2 non-locking.
1. Insert casters into four holes on
bottom of unit. The stem should
fit snugly into hole.
NOTE Install both locking casters on
the same side (front or back) to
ensure equal and secure locking
Fill with Water
The reservoir on this unit holds 3.8 gallons.
1. To fill the reservoir, open the water fill door
at the back and fill with fresh, clean water
using a fill hose or pitcher. DO NOT
OVERFILL.
CAUTION: If moving the unit for filling, make
sure the casters are unlocked for easy mobility.
Do not tip unit.
.
2
WATER
ACCESS
DOOR
Need help?
Do you have a question about the CP35 and is the answer not in the manual?
Questions and answers