Adjust The Image And Focus; Accessing The Axis 211W From The Internet - Axis 211W User Manual

Page 12

Adjust the image and focus

To focus the AXIS 211W follow the instructions below.
1. From the Basic Configuration page in
the setup tools, open the Focus adjust-
ment page.
2. Set the DC-Iris to Disabled and click
Save.
3. Unscrew the zoom puller on the lens by
turning it anti-clockwise. Adjust the
zoom setting as required. Re-tighten the
zoom puller.
4. Unscrew the focus puller on the lens.
Adjust the focus as required. Re-tighten
the focus puller.
5. From the Focus adjustment page, set the
DC-Iris to Enabled and click Save.
Note:
The DC-Iris should always be dis-
abled while focusing the camera. This
opens the iris to its maximum, which
gives the smallest depth of field and thus the best conditions for correct focusing.
When the focus is set with this method it will then be maintained in any light
conditions.

Accessing the AXIS 211W from the Internet

Once installed, your AXIS 211W is accessible on your local network (LAN). To access the
camera from the Internet, network routers must be configured to allow incoming traffic,
which is usually done on a specific port. Please refer to the documentation for your router
for further instructions. For more information on this and other topics, visit the Axis Support
Web at www.axis.com/techsup
AXIS 211W Installation Guide
Zoom puller
(Tele/wide)
Focus puller