D-Link DAP-2310 User Manual page 70

Section 6 - Troubleshooting
%QP IWTG [QWT +PVGTPGV UGVVKPIU
)Q VQ Start > Settings > Control Panel. Double-click the Internet Options Icon. From the Security tab,
click the button to restore the settings to their defaults.
%NKEM VJG Connection tab and set the dial-up option to Never Dial a Connection. Click the LAN Settings
button. Make sure nothing is checked. Click OK.
)Q VQ VJG Advanced tab and click the button to restore these settings to their defaults. Click OK three
times.
%NQUG [QWT YGD DTQYUGT KH QRGP CPF QRGP KV
#EEGUU VJG YGD OCPCIGOGPV 1RGP [QWT YGD DTQYUGT CPF GPVGT VJG +2 CFFTGUU QH [QWT &.KPM CEEGUU RQKPV KP VJG
address bar. This should open the login page for your the web management.
+H [QW UVKNN ECPPQV CEEGUU VJG EQP IWTCVKQP WPRNWI VJG RQYGT VQ VJG CEEGUU RQKPV HQT  UGEQPFU CPF RNWI DCEM KP
9CKV CDQWV  UGEQPFU CPF VT[ CEEGUUKPI VJG EQP IWTCVKQP +H [QW JCXG OWNVKRNG EQORWVGTU VT[ EQPPGEVKPI WUKPI C
different computer.
 9JCV ECP + FQ KH + HQTIQV O[ RCUUYQTF!
If you forgot your password, you must reset your access point. Unfortunately, this process will change all your settings
back to the factory defaults.
6Q TGUGV VJG CEEGUU RQKPV NQECVG VJG TGUGV DWVVQP JQNG QP VJG TGCT RCPGN QH VJG WPKV 9KVJ VJG CEEGUU RQKPV RQYGTGF
on, use a paperclip to hold the button down for 10 seconds. Release the button and the access point will go through
its reboot process. Wait about 30 seconds to access the access point. The default IP address is 192.168.0.50. When
logging in, the username is admin and leave the password box empty.
D-Link DAP-2310 User Manual 70