Field Programming Equipment; Table 4. Service Aids - Motorola ASTRO XTS 5000 I Basic Service Manual

Recommended Test Equipment and Service Aids
Motorola Part
Number
81-80384M64
58-80348B33
66-85833D01
NLN9839_
NTN4265_
NTN9279_
REX4424_
RKN4105_
RKN4106_
RLN4460_
RVN4181_
Field Programming
Equipment
12
standard shop equipment items, and any equivalent item capable of
the same performance may be substituted for the item listed.

Table 4. Service Aids

Description
Housing Eliminator Fixture
SMA to BNC Adaptor
Housing/Casting Separation
Tool
Vacuum Pump Kit
Pressure Pump Kit
Vacuum Adapter with Gasket
Kit
Battery Eliminator
USB Cable Kit
RS232 Cable Kit
Portable Test Set
Customer Programming
Software (CPS) and Tuner
Software
This family of radios can be aligned and programmed in the field. This
requires specific equipment and special instructions. Refer to the on-
line help in the Customer Programming Software (CPS) for complete
field programming information.
Application
Special fixture that allows radio's internal board to be
mounted externally. Provides easy access to electronic
circuits, required for board-level troubleshooting.
Adapts radio's antenna port to BNC cabling of test
equipment.
Special tool used to separate housing and casting near
battery latch area for access to inside of radio.
Submersible radios only. Vacuum pump with gauge and
vacuum hose. Requires NTN9279_ Adapter Kit.
Submersible radios only. Pressure pump with gauge and
pressure hose. Requires NTN9279_ Adapter Kit.
Submersible radios only. Connects the vacuum/pressure
hose to the radio's casting.
Used in place of battery to connect radio to external power
supply.
Connects radio to RLN-4460_ Portable Test Set for radio
performance checks, and to Universal Serial Bus (USB) port
on personal computer for CPS programming and tuner
alignments.
Connects radio to RLN-4460_ Portable Test Set for radio
performance checks, and to serial port on personal
computer for CPS programming and tuner alignments.
Used for radio performance checks. Connects to radio's
universal connector and allows remote switching and signal
injection/outputs for test equipment measurements.
CPS allows customer-specific programming of modes and
features. Tuner software required to perform alignment of
radio parameters. Can be used for both XTS 5000 and XTS
2500 products.