Troubleshooting - Electrolux EWG 147410 W User Manual

22 www.electrolux.com
WARNING!
Make sure that the
temperature is more than 0
°C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
12.9 Emergency emptying out
If the appliance does not drain the water,
proceed as follows:
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. If necessary, wait until the water has
cooled down.

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
13.1 Introduction
The appliance does not start or it stops
during operation.
First try to find a solution to the problem
(refer to the table). If the problem
persists, contact the Authorised Service
Centre.
With some problems, the acoustic
signals operate and the display shows
an alarm code:
• - The appliance does not fill with
water properly.
4. Place a bowl on the floor and put the
end of the emergency emptying hose
into the bowl. Remove its cap.
The water should drain by gravity into the
bowl.
5. When the bowl is full, put the cap
back on the emergency hose.
6. Empty the bowl. Repeat the
procedure until water stops flowing
out.
7. Clean the pump if necessary as
previously described.
8. Replace the emergency emptying
hose in its seat after having plugged
it.
9. Screw the water inlet hose back on.
• - The appliance does not drain
the water.
• - The appliance door is open or
not closed correctly. Please check the
door!
• - The mains supply is unstable.
Wait until the mains supply is stable.
• - No communication between
electronic elements of the appliance.
Switch off and switch on again.
WARNING!
Deactivate the appliance
before you do the checks.