Installation - Electrolux EWG 147410 W User Manual

24 www.electrolux.com
Problem
There is water on the
floor.
You cannot open the
appliance door.
The appliance makes
an unusual noise.
The washing results
are not satisfactory.
After the check, activate the appliance.
The programme continues from the point
of interruption.
If the problem occurs again, contact the
Authorised Service Centre.

14. INSTALLATION

14.1 Unpacking
WARNING!
Remove all the packaging and the transit bolts before installing the
appliance.
Possible cause/solution
Adjust manually the items in the tub and start the spin
phase again. This problem may be caused by balance
problems.
Make sure that the couplings of the water hoses are tight
and there is not water leakages.
Make sure that the drain hose have no damages.
Make sure you use the correct detergent and the correct
quantity of it.
Make sure you have replaced the emergency emptying cap
into the filter
Make sure you have properly screwed the filter in after
cleaning.
Make sure that the washing programme is finished.
Set the drain or the spin programme if there is water in the
drum.
Make sure the levelling of the appliance is correct. Refer to
'Installation'.
Make sure that the packaging and/or the transit bolts are
removed. Refer to 'Installation'.
Add more laundry in the drum. The load may be too small.
Increase the detergent quantity or use a different detergent.
Use special products to remove the stubborn stains before
you wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
If the display shows other alarm codes.
Deactivate and activate the appliance. If
the problem continues, contact the
Service.