Miscellaneous; Supervisory Tones - E.F. Johnson Company 4100 SERIES Operating Manual

7.1 SUPERVISORY TONES

Single Beep (Alert Tone)
•
Power was turned on and a successful power-up
sequence occurred (Section 3.1).
•
The time-out timer is about to expire or the penalty
timer has expired (Section 4.3).
•
The conversation timer is about to expire (Section
5.7).
•
The system received your page but the paged radio
is not on the air (Section 6.7).
•
Telephone interconnect is not operational (Section
6.6).
Continuous Tone (Invalid Condition)
•
A transmission is being attempted on a conventional
channel programmed as receive-only.
•
The transmitter is disabled by the busy channel
lockout feature (Section 5.4).
•
The transmitter has been disabled by the time-out
timer feature (Section 4.3).
•
The transmitter has been disabled by the conversa-
tion timer (Section 5.7).
•
An out-of-range condition exists (SMARTNET/
SmartZone and P25 trunking only).
•
A transmission is being attempted before the penalty
timer has expired (Section 5.6).
•
Dynamic regrouping has been exited but the
dynamic regrouping channel is still selected
(Section 6.13).
Single Short Medium-Pitch Tone
•
A valid key has been pressed.
Single Short Low-Pitch Tone
•
An invalid key has been pressed.
Medium Tone (No Acknowledge)
•
The paged radio did not acknowledge the page
(Section 6.7).
SECTION 7 MISCELLANEOUS
53
•
The message that was sent has not been acknowl-
edged (Section 6.8).
•
The status condition that was sent has not been
acknowledged (Section 6.9).
Five Beeps (Recurring)
•
The page was received (Section 6.7).
Two Short Tones
•
A private call was received (Section 6.5).
Five Beeps
•
The paged radio received the page and acknowl-
edged it (Section 6.7).
•
The message that was sent has been received and
acknowledged (Section 6.8).
•
The status condition that was sent has been received
and acknowledged (Section 6.9).
Four Beeps
•
The emergency alarm condition was acknowledged
(Section 6.10).
•
Four low tone beeps indicate call back mode (the
system is no longer busy)
Alternating Tone
•
Dynamic regrouping has occurred (Section 6.13).
•
Dynamic regrouping has occurred but the
regrouping channel is not selected (Section 6.13).
Busy Signal
•
The radio system is busy or a busy condition exists
when making a telephone call.
Three Medium Pitch Tones
•
A channel is available after a busy condition
occurred (SMARTNET/SmartZone only).

MISCELLANEOUS