Initial Operation; Connection Of The Director To The Dsp; Activation Of The Director - Audiotec Fischer DIRECTOR User Manual

3. Initial operation

3.1 Connection of the DIRECTOR to the DSP

After turning on the sound system the DIRECTOR will automatically establish a connection to the DSP.
The window is shown on the DIRECTOR`s screen during connection. Pressing the D IRECTOR Update activates an
update mode for the internal DIRECTOR`s firmware.
Note: The connection setup can take a few seconds.

3.2 Activation of the DIRECTOR

In order to use the DIRECTOR the device has to be activated / registered in the DSP. If the connection is successfully
done and the D IRECTOR is not activated / registered in the DSP the following message will appear:
By confirming the warning message the DIRECTOR will be temporarily activated.
Note: The temporary activation has to be repeated after every restart. For safety reasons the volumes for HEC/MEC/
AUX and Digital Optical will be set to -60 dB (mute) after confirming the warning message.
It is strongly recommended to permanently activate the DIRECTOR in the DSP PC-Tools DCM menu.
33