Rear Wheel Replacement; Front Wheel Alignment - Roketa GK-13 Owners Manual, Assembly Manual, And Parts List

2. Rear Wheel Replacement
Do not disassemble the castle nuts when you replace the
front wheels.
It is only necessary to tighten the nuts so that the wheel
turns freely on the axle with minimum end play. (See picture
13) Tighten the nuts and put on the cotter Pin after replacing
the wheels.
3. Front Wheel Alignment
The front wheels should be toe-in from 1/8" to 1/4". To check for alignment, measure distance
A and B between the centerline (CL) of the wheels. The proper toe-in dimension A should be
1/8" to ¼" greater than dimension B.
To adjust the alignments, loosen the lock nuts on both sides of Front Tie Rods. To make
Dimension B smaller, adjust the rod to the left. Adjust the rod to right direction to make
Dimension B larger. After adjusting to desired length, tighten the lock nut against the rod end
Recheck the dimensions for proper alignment.