JVC KD-AR470 Service Manual page 110

ELECTRICAL CONNECTIONS
A
Typical Connections
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious damage to this unit.
The leads of the power cord and those of the connector from the car body may be different in color.
1
Connect the colored leads of the power cord in the order specified in the illustration below.
2
Connect the antenna cord.
3
Finally connect the wiring harness to the unit.
To CD changer or another external component (see diagram
Rear ground
terminal
Line out (see diagram
Antenna terminal
* 2
Before checking the operation of this unit prior to
installation, this lead must be connected, otherwise
power cannot be turned on.
White with black stripe White
Left speaker (front)
B
Connecting the external amplifier
You can connect amplifiers to upgrade your
car stereo system.
• Connect the remote lead (blue with white
stripe) to the remote lead of the other
equipment so that it can be controlled
through this unit.
• Disconnect the speakers from this unit,
connect them to the amplifier. Leave the
speaker leads of this unit unused.
C
Connecting the external components
• Set "CHANGER" for the external input setting (see page 13 of the INSTRUCTIONS.)
®
CD changer, Apple iPod , or JVC D. player
You can connect these components as illustrated below. The iPod*
be connected using an interface adapter (not supplied)—KS-PD100 (for iPod) or
KS-PD500 (for D. player).
CD changer jack
• Set "EXT IN" for the external input setting (see page 13 of the INSTRUCTIONS.)
External Component
CD changer jack
)
15 A fuse
)
Black
* 2
Yellow
Red
Blue
Blue with white stripe
Orange with white stripe
Gray with black stripe Gray
Right speaker (front)
Rear speakers
JVC Amplifier
5 or D. player can
JVC CD changer
External component
3.5 mm stereo mini plug
* 1 Not supplied for this unit.
To metallic body or chassis of the car
To a live terminal in the fuse block connecting to the car battery
(bypassing the ignition switch) (constant 12 V)
To an accessory terminal in the fuse block
To the automatic antenna if any (250 mA max.)
To the remote lead of other equipment (200 mA max.)
To car light control switch
Green with black stripe Green
Left speaker (rear)
Remote lead Y-connector (not supplied for this unit)
Remote lead (Blue with white stripe)
Front speakers
Apple iPod
(separately purchased)
or
JVC D. player
(separately purchased)
External component
2
Ignition switch
Fuse block
Purple with black stripe Purple
Right speaker (rear)
To the remote lead of other
equipment or auto antenna if any
* 3 Firmly attach the ground wire to the metallic body
or to the chassis of the car—to the place not coated
with paint (if coated with paint, remove the paint
before attaching the wire). Failure to do so may cause
damage to the unit.
* 4
Signal cord (not supplied for this unit)
CAUTION:
• Before connecting the CD changer, make
sure that the unit is turned off.
* 5
iPod is a trademark of Apple Computer, Inc.,
registered in the U.S. and other countries.
* 6
Connecting cord supplied for your CD changer
* 7
Line Input Adapter KS-U57 (not supplied for this unit)
* 8
AUX Input Adapter KS-U58 (not supplied for this unit)