Verify Signal Field Range; Changing The Channel Setting; Boundary Plus Operation; Adjust Signal Field Range - INVISIBLE FENCE Invisible Gate Plus Owner's Manual



Verify Signal Field Range

o
Holding the Computer Collar
towards the Invisible Gate
this time.
o
The Computer Collar
signal field width set in Step 2. The beeping will be accompanied by a correction.
o
If the Computer Collar
11.
o
Adjust range and/or relocate the Invisible Gate
area is protected.

Changing the Channel Setting on the Invisible Gate
o Remove the control panel cover.
o Press and release the RANGE DOWN (-)
button until 0 appears on the LCD.
o Locate the switch for the Channel (A),
Channel (B) and (A+B) Channel.
o Select the desired channel setting.
Note: The Invisible Gate
will not enter into programming mode if
the switch is set to A+B. See Programming
Computer Collar
o Adjust and verify signal field range.
o Replace the control panel cover and hand
tighten the four screws.
Note: Ensure the O-ring is seated in the
channel before replacing the control panel
cover. Failure to do so may allow moisture
leakage and possible failure of the device.
®
Boundary Plus
® mode your pet's Computer Collar
In Boundary Plus
®
Invisible Gate Plus transmitter. This patented technology allows you to position the transmitter in
a doorway to prevent entry into a room without impeding your pet's movement near the
transmitter. Ensure the BOUNDARY PLUS/SHIELDS switch is in the Boundary Plus


Adjust Signal Field Range

o Determine the desired location and the signal field range required.


o With the unit ON, press the RANGE UP (+) or the RANGE DOWN (-) buttons to increase or
decrease the signal field range. The first indicator equals 10 inches of signal field. Each additional
number represents approximately 6 inches of range.
®
unit will beep as it approaches the outer range of the
®
unit fails to beep, see the troubleshooting chart on page
®
®
unit on Page 9
Operation:
Wireless: 10 inch minimum up to 34 inch maximum signal field height.
Signal field should be set to activate your pet's Computer Collar
above where sits on your pet neck.
®
unit, start outside the range and move slowly
®
Plus transmitter. Do not touch the correction posts at
®
Plus transmitter
Plus transmitter
®
unit will activate as your pet crosses over the
www.InvisibleFence.com
®
Plus transmitter until desired
Control Panel
®
position
.
®
unit 10 to 16 inches
8