Specifications - Audio Technica M2 Set Up And Operation Manual

P52001_M2-System_OM 2/13/08
12

Specifications

Overall System
UHF Operating Frequencies
Minimum Frequency Step
Modulation Mode
Maximum Deviation
Dynamic Range
Total Harmonic Distortion
Operating Range
Operating Temperature Range
Frequency Response
Simultaneous Use
Receiver
Receiving System
RF Sensitivity
Headphone Output Connector
Headphone Output Power
Antenna Input
Aux Input Connector
Batteries
Battery Life
Dimensions
Net Weight
Accessories Included
Transmitter
RF Power Output
Spurious Emissions
Input Connection
Maximum Input Level
Loop Output Connection
Power Requirement
Antenna
Dimensions
Net Weight
Accessories Included
† Specifications are subject to change without notice.
4:16 PM Page 12
†
Band Frequency Range
Band E: 790.000 to 822.000 MHz 100
Band F: 832.000 to 865.000 MHz 100
Band L: 575.000 to 608.000 MHz 100
Band M: 614.000 to 647.000 MHz 100
Not all frequency bands available in all areas.
Please check with local regulations.
25 kHz
FM stereo
±40 kHz
90 dB (typical), A-weighted
<1% (at 1 kHz, ±20 kHz Deviation)
100 m (300'), typical
Open range environment with no interfering signals.
-5° C (23° F) to 50° C (122° F)
Battery performance may be reduced at very low temperatures.
60 Hz to 13 kHz (±3 dB)
10 channels per band (maximum recommended)
For assistance with multi-band operation or other frequency
coordination issues, please contact your regional
Audio-Technica customer service representitive.
Double conversion superheterodyne
20 dBuV (at 60 dB S/N ratio, 50 ohms termination)
3.5 mm TRS stereo phone jack
65 mW (at 32 ohms)
SMA-type, 50 ohms
3.5 mm TRS stereo phone jack
2 x 1.5V AA (not included)
8 hours (alkaline)
Depending on battery type and use pattern
70.0 mm (2.76") W x 25.0 mm (0.98") D x 110.0 mm (4.33") H
110 g (3.9 oz), without batteries
EP3 earphones; frequency sticker; flexible antenna
10 mW/30 mW (switchable), 50 ohms
Limited to 10 mW within 863 MHz to 865 MHz.
Following national regulations.
Following federal and national regulations
XLRF-type/6.3 mm stereo (
Pin 1 and Sleeve: Ground
Pin 2 and Tip: Hot
Pin 3 and Ring: Cold
XLRF-type/6.3 mm stereo (
6.3 mm ( 1 / ") mono, unbalanced: +26 dBu
4
XLRM-type connector
Pin 1: Ground
Pin 2: Hot
Pin 3: Cold
12-18V DC, 600 mA
Attached whip
210.0 mm (8.30") W x 132.0 mm (5.20") D x 44.0 mm (1.70") H
870 g (30.7 oz.), without accessories
AC adapter (country dependant); rack-mount adapters
Number of Frequencies
1 / ") combination connector
4
1 / "), balanced: +26 dBu
4