Audio Technica M2 Set Up And Operation Manual page 3

P52001_M2-System_OM 2/13/08
M2 System Components
M2R
UHF Stereo Receiver
Quick-start guide
1. Plug in the included AC adapter and connect to transmitter's DC input.
2. Insert 2 AA batteries in the M2R Stereo Receiver following polarity
as indicated.
3. Set M2R Stereo Receiver and M2T Stereo Transmitter to the same
frequency. ( See page 8. )
4. Power on M2R Stereo Receiver with volume in minimum position;
power on M2T Stereo Transmitter. Check to see that RF LED on
M2R Stereo Receiver is illuminated.
5. Power off receiver and transmitter.
4:16 PM Page 3
M2T
UHF Stereo Transmitter with
AC adapter
EP3
Dynamic Earphones
6. Connect audio source(s) to inputs on the rear panel of the transmitter.
7. Power on M2T Stereo Transmitter.
8. Adjust attenuator on rear panel of M2T Stereo Transmitter to
appropriate level. ( See page 5. )
9. Adjust trim level on front panel of M2T Stereo Transmitter, if needed.
( See page 8. )
10. Plug supplied Dynamic Earphones into earphones locking output
jack on M2R Stereo Receiver. NOTE: Do not put the earphones
in your ears at this point.
11. Turn on receiver with volume in minimum position.
12. With volume on receiver at minimum position, put earphones into
your ears and gradually increase volume until appropriate level is
reached.
3
EN