Disassembly Instructions; Removal Of Mechanical Parts And P.c.boards; Top Cabinet And Front Cabinet; Flap - JVC HR-XV1EK Service Manual

1. REMOVAL OF MECHANICAL PARTS
AND P.C. BOARDS
1-1:

TOP CABINET AND FRONT CABINET

(Refer to Fig. 1-1)
Remove the 5 screws 1.
1.
2. Remove the Top Cabinet in the direction of arrow (A).
3. Disconnect the following connector: (CP681).
Unlock the 8 supports 2.
4.
5. Remove the Front Cabinet in the direction of arrow (B).
Remove the 3 screws 3.
6.
7. Remove the Operation PCB in the direction of arrow (C).
1
Front Cabinet
(B)
2
3
2
2
2
2
(C)
2
2
2
1-2: FLAP (Refer to Fig. 1-2)
1. Open Flap to 90˚ and flex in direction of arrow (A), at the
same time slide in direction of arrow (B).
2. Then lift in direction of arrow (C).
(C)

DISASSEMBLY INSTRUCTIONS

1
Top Cabinet
1
(A)
1
3
3
Operation PCB
CP681
Fig. 1-1
(A)
(B)

Flap

Fig. 1-2
1-3: DECK CD AND DVD PCB (Refer to Fig. 1-3)
1. Make the short circuit on the position as shown Fig. 1-3
using a soldering. If you remove the Deck CD with no
soldering, the Laser may be damaged.
2. Disconnect the following connectors: (CP503,CP8001
and CP8002).
Remove the 4 screws 1.
3.
4. Remove the Deck Angle in the direction of arrow (A).
Remove the 2 screws 2.
5.
6. Remove the Front-DVD Shield in the direction of arrow
(B).
Remove the 4 screws 3.
7.
8. Disconnect the following connectors: (CP2601, CP2602
and CP2603).
9. Remove the Deck CD in the direction of arrow (C).
Remove the 4 screws 4.
10.
11. Remove the DVD PCB in the direction of arrow (D).
1
Deck CD
Front-DVD Shield
2
2
NOTE
When the installation of the Deck CD, remove all the solder-
ing on the short circuit position after the connection of Pick
Up PCB and DVD PCB connector.
3
3
3
3
1
Deck Angle
1
(C)
1
(B)
1
(D)
CP2601
DVD PCB
4
4
4
4
CP2603
CP2602
CP8001
(A)
CP503
CP8002
Pick Up PCB
Make the sort circuit
using a soldering.
Fig. 1-3
1-1