Table of Contents
Advertisement
FO-145A
[2] Disassembly and assembly procedures
This chapter mainly describes the disassembly procedures. For the assembly procedures, reverse the disassembly procedures.
Easy and simple disassembly/assembly procedures of some parts and units are omitted. For disassembly and assembly of such parts and units,
refer to the Parts List.
@ The numbers in the illustration, the parts list and the flowchart in a same section are common to each other.
* To assure reliability of the product, the disassembly and the assembly procedures should be performed carefully and deliberately.
1
Rear cover, handset holder ass'y
1
a. Remove the rear cover and the handset holder ass'y.
<Note 1> How to remove handset holder ass'y 6.
Push and remove pawl @ on the right side in the
arrow direction shown in the enlarged view. Then push
and remove pawl @ on the left side.
Parts list (Fig. 1)
I
No.
I
Part name
\ Q'ty I
Q
1
1
~Lower cabinet
1
2!
Screw (3x10, black)
2
I
1
r
!
3
\ Rear cover
II
I
8L
24
4
Screw (3x1O,black)
4
5
Handset holder ass'y
1
356
~
Hook switch lever
1
[
I
1
n
7
I
7
I Screw
1
I
6
8
i
Spool
1
8
9
~Spool spring
1
0
9
Fig. 1
[Note for assembly]
1.
When assembling handset holder ass'y @ in Fig. 1, note the
following items.
Insert two pawls ~
and @ in Fig. 1 into the groove in the
lower cabinet.
* Put the right edge of the handset holder cabinet inside the
lower cabinet.
Lock two pawls @ in Fig. 1 securely.
Check that three sensor levers @ in Fig. 1 move smoothly.
3–4
Advertisement
Table of Contents
