Table of Contents
Advertisement
3.2.7 Removing the switch board
(See Figure 13)
• Remove the DVD mechanism assembly.
(1) From the top side of the DVD mechanism assembly, re-
move the screw H attaching the switch board.
(2) Lift the switch board slightly and then remove the wire from
connector
CN101
on the switch board.
3.2.8 Removing the loading motor assembly
(See Figure 1, Figure 13, Figure 14, Figure 15)
• Remove the DVD mechanism assembly.
(1) From the back side of the DVD mechanism assembly, dis-
connect the card wire from connector
servo control board. (See Figure 1)
(2) From the top side of the DVD mechanism assembly, re-
move the two screws I attaching the clamper base assem-
bly.
(3) Disconnect the wire from connector
board while lifting the clamper base assembly slightly and
remove the clamper base assembly.
(4) Remove the screw K attaching the roller holder assembly.
(See Figure 1)
(5) Remove the three screws J attaching the roller holder as-
sembly and take out the roller holder assembly.
(6) Disconnect the wires from connectors
on the loading motor assembly.
(7) Remove the belt of the loading motor assembly.
(8) Remove the two screws L attaching the loading motor as-
sembly and take out the loading motor assembly.
CN202
on the DVD
CN101
on the switch
CN103
and
CN104
Roller holder
assembly
DVD mechanism assembly
H
CN101
I
Switch board
Fig.13
J
Fig.14
CN103
L
Fig.15
Clamper base assembly
I
J
Roller holder
assembly
CN104
Loading motor assembly
L
Belt
(No.XA010)1-17
Advertisement
Chapters
Table of Contents
