Table of Contents
Advertisement
3.1.5 Removing the power supply board (See Figure 9)
• Prior to the following procedure, remove the top cover, the
front panel assembly, and the hard disc.
(1) Disconnect the card wire from the connector
power supply board.
(2) Disconnect the power cord from the socket
power supply board.
(3) Disconnect the 2-pin wire from the connector
power supply board.
(4) Remove the four screws K attaching the power board.
3.1.6 Removing the SCART terminal board (See Figure 10)
• Prior to the following procedure, remove the top cover.
(1) Disconnect the card wire from each connector CN701,
CN702, CN902, CN903, and
nal board.
(2) Remove the two screws I and M attaching the lug wire.
(3) Remove the two screws L attaching the SCART terminal
board.
(4) Remove the two fasteners.
3.1.7 Removing the main board (See Figure 11)
• Prior to the following procedure, remove the top cover, the
front panel assembly, the hard disc, the DVD mechanism as-
sembly, the power board, and the SCART terminal board.
(1) Remove the four screws M attaching the main board.
(2) Remove the seven screws N attaching the main board on
the rear side.
1-12 (No.XA010)
CN95
on the
CN91
on the
CN92
on the
CN904
on the SCART termi-
Power supply board
K
K
CN92
CN91
Fig.9
I
CN701
CN903
K
L
CN904
CN902
Fig.10
M
M
Main board
N
Fig.11
K
K
CN95
CN702
Fastener
M
L
SCART terminal board
M
M
Advertisement
Chapters
Table of Contents
