Advertisement
MOU TI G I STRUCTIO S
⚠
Warninge!
We strongly recommend to have an Öhlins dealer install
this product.
⚠
Warninge!
If working on a raised vehicle, ensure that it is securely
supported to prevent it from tipping over.
otee!
1
When working on this product, see the Vehicle Service
Manual for vehicle specific procedures and important data.
1
Raise the vehicle, use jack stands.
2
Remove the rear wheels.
3
Remove the lower and the upper attachments
and remove the original shock absorbers.
4
Cut the dust boot 82 mm from the lower end
according to the figure.
5
Assemble the shock absorber according to
the figure. Do not install the adjuster knob and
screw yet.
4
5
Lock ring
Lower
bracket
6
Washer
Original spacer
Adjuster screw
Adjuster knob
Adjuster cable
Adjuster
Lock nut M10
Washer
Original bushing
Vehicle body
Original spacer
Original rubber
cover
Original bushing
Original washer
Dust boot
Bushing spacer
Advertisement
