Hookups With A Cable Box - Philips VPZ210AT Owner's Manual

VPZ210/VPZ215 4/3/99 3:16 PM
This connection allows you to view any channel. After you connect the VCP, Cable Box, and
TV as shown below, the features on this page will be available.
1. Connect a Cable
signal to the VCP's
ANT(enna) IN Jack.
CH3
CH4
Watching TV With the VCP Off
1
Use the TV channel selector to set the TV to the Cable
Box output channel (channel 3 or 4).
2
Select the channel you want to watch at the Cable Box.
Playing a Tape
1
Make sure the Cable Box is on the same channel as the
VCP's CH3/CH4 switch.
2
Use the TV channel selector to put the TV on the Cable
Box output channel (channel 3 or 4).
3
Press the PLAY button to play the tape.
Page 9
2. Use an RF coaxial cable (supplied) to connect
the ANT(enna) OUT Jack on the VCP to the IN
Jack on the Cable Box.
ANT OUT
ANT IN
3. Use a second RF coaxial cable to connect the OUT Jack on
the Cable Box to the ANTENNA IN Jack on the back of the TV.
Hookups With a Cable Box (cont'd) 9
IN
OU T
TV ANTENNA IN Jack