Advertisement
Available languages
Available languages
° Lock t hePower Unit b ysetting the forward/reverse
slider (2) tothe
center position.
° To remove anattachment,
depress the release button (4) and take
theattachment
off t he tool.
• To fitanattachment,
line itupwith the tool a sshown and push i tonto
thePower Unit until itsnaps into place a nd anaudible click i sheard.
° Ensure that a ttachment
issecurely attached bygently p u!fing onit
inthe opposite direction from thePower Unit.
NOTE: Only u se attachments
that a re specifically
designed
forand
compatible
with thePower Unit.
NOTE: Refer toindividual
attachment
instruction
manuals forspecific
safety warnings and operating
instructions
before o perating
attach-
ments with thePower Unit.
OPERATUNG:
DRULL/SCREWDRUVER
ATTACHMENT
z_SAFETY
WARNINGS
AND INSTRUCTIONS:
DRILLS
t,
Hold drill firmly with one hand on the grip and the other hand on the bottom of the battery pack
unless an auxiliary handle has been supplied with the tool Use auxiliary handle if supplied with
the tool.
2. When attaching accessories in the drill chuck, hand tighten the keyless chuck firmly.
z_ WARNING:
Drill may stall (if overloaded or improperly used) causing a twist. Always expect the
stall. Grip the drill firmly with both hands to control the twisting action and prevent loss of control which
could cause personal injury. If a stall does occur, release the trigger immediately and determine the
reason for the staff before re-starting.
z_WARNING:
Let the tool work at its own pace. Do not overload.
z_WARNING:
Before drilling into wails, floors or ceilings, check for the location of wiring and pipes.
FITTING AND REMOVING
A DRmLL BIT OR SCREWDRIVER
BIT
The drill/screwdriver attachment (9) is fitted with a keyless chuck (10) to allow for an easy exchange
of bits.
° Lock the tool by setting the forward/reverse slider (2) to the center position.
° Open the chuck by turning the front part clockwise with one hand while holding the rear part with
the other.
° Insert the bit shaft into the chuck.
° Firmly tighten the chuck by turning the front part counterclockwise.
° To remove the screwdriver bit from the holder (5) on the Power Unit, lift the bit from the recess.
° To store the screwdriver bit, firmly push it into the holder.
SCREW DRmVING
° Always use the correct type and size of screwdriver bit.
° If screws are difficult to tighten, try applying a small amount of washing liquid or soap as a lubricant.
° Always hold the tool and screwdriver bit in a straight line with the screw.
° For driving fasteners, the reversing button should be pushed to the left (as viewed from rear of
tool). Use reverse (button pushed to the right) for removing fasteners. When moving from forward
to reverse, or vice versa, always release the trigger switch first.
KEYLESS
CHUCK - FIGURE E
z_WARNING:
To reduce the risk of injury, turn off and remove battery from the tool before
making any adjustments or removing or installing attachments or accessories.
z_ WARNING:
Do not attempt to tighten or !oosen drili bits (or any other accessory) by gripping the
front part of the chuck and turning the tool on. Damage to the chuck and personal injury may occur.
10
Advertisement
