Safety Information; Declaration Of Confirmation; Additional Information; Getting Started - LG BTS1 Owner's Manual

2

Getting Started

Safety Information

Declaration of Confirmation

1
FCC Notice to Users:
This device complies with part 15 of the FCC rules.
Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference
and
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
Important Note:
To comply with the FCC RF exposure compliance
requirements, no change to the antenna or the
device is permitted. Any change to the antenna or
the device could result in the device exceeding the
RF exposure requirements and void user's authority
to operate the device.
Federal Communication Commission
Interference Statement:
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced Radio/TV
technician for help.
CE Notice to Users:
Hereby, LG Electronics Inc. declares that this device
is in compliance with the essential requirements
and other relevant provisions of Directive 1999/5/
EC.
FCC ID: SSNBTS1

Additional Information

1. Radio frequency exposure
This device is a radio transmitter and receiver. When
in operation it communicates with a Bluetooth®
equipped mobile device by receiving and
transmitting radio frequency (RF) electromagnetic
fields (microwaves) in the frequency range 2.4
to 2.4835 GHz. The output power of the radio
transmitter is low (0.001 W). This device is designed
to operate in compliance with the RF exposure
guidelines and limits set by national authorities
and international health agencies when used any
compatible LG Electronics mobile phone.
2. Potentially explosive atmosphere
Turn off your electronic device when in any area
with a potentially explosive atmosphere. Although
this is uncommon, your electronic device could
generate sparks. Sparks in such areas could cause
an explosion or fire resulting in bodily injury or
even death. Areas with a potentially explosive
atmosphere are often, but not always, clearly
marked.
3. Emergency calls
IMPORTANT!
This device and the electronic device connected to
the headset operate using radio signals, mobile and
landline networks as well as user - programmed
functions, which cannot guarantee connection
under all conditions. Therefore you should never
rely solely upon any electronic device for essential
communications (e.g. medical emergencies).
Remember, in order to make or receive calls, the
headset and the electronic device connected to the
headset must be switched on and in a service area
with adequate mobile signal strength. Emergency
calls may not be possible on all mobile phone
networks or when certain network services and/
or phone features are in use. Check with your local
service provider.