Energizer ENX12K User Manual page 5

OPERATING INSTRUCTIONS
Make sure power level is above 50% before use:
Indicator
Battery charger
Plug the blue connector into the 12V Jump Starter port (A); LED (B)
1.
illuminates red.
Connect the red damp to positive '+' on the vehicle's battery. Connect the
2.
black clamp to negative '-' on the vehicles battery. lf connected correctly LED (B)
illuminates green. lf LED flashes red it's more than likely the clamps have been
incorrectly connected, remove clamps & connect correctly, the LED should now
be green. Even if with the clamps connected correctly the LED flashes red,
remove the red clamp & re-connect to reset.
If Green, proceed to start vehicle.
3.
Once the vehicle has started and the LED flashes green, disconnect the
4.
clamps from the vehicle's battery and then remove the jumper cables from the jump
starter.
Recharging the Jump starter
To charge the jump starter, connect D and A with C then plug the charger (D)
into a 110V outlet. The four Indicator lights will flash. When the four Indicator
lights are solid illuminated, the jump starter battery is completely charged.
0 1 2
0% 25% 50%
3 4
75% 100%