Table of Contents
Advertisement
- -
3.3
Installing the equipment
It is assumed that the installer has already installed the other peripheral equipment (cable trays, multiplexes,
etc).
3.3.1 - - Information required for installation
Appendix 2 contains a sheet for you to complete to collate all the general information needed for the installation
procedure.
3.3.2 - - Precautions concerning electromagnetic compatibility (EMC) and safety
1) Installation is designed to meet all new requirements concerning electromagnetic compatibility and safety.
2) The EMC performance of the equipment depends largely on installation practices (cable installation, earthing
connections, etc) which should be based on best trade practices.
3.3.3 - - Tools required
The list of the tools required to install the microwave links of the 9400 UX family is given below (applies to all
frequency bands).
Tool
2.5 mm Allen key (for M3 screw)
3 mm Allen key (for M4 screw)
5 mm Allen key (for M6 screw)
6 mm Allen key (for M8 screw)
8 mm Allen key (for M10 screw)
"Pipe" wrench and 13 mm flat
wrench
16/17 mm box wrench and flat
wrench
16/17 mm torque wrench
5 mm flat wrench
8 mm flat torque wrench, Radiall,
code: R282320
20 mm flat torque wrench
3.5 x 100 mm screwdriver
(for slotted head screws)
10 x 100 mm screwdriver
(for slotted head screws)
Manually or with a screwdriver
(for slotted head screws)
The above tools marked with an "x" are included in a "station toolkit", ref: 9400UXT103.
Depending on installation, additional equipment may be useful:
--
"Mars Actel" OSA3 Compax insertion and extraction tool, for wiring compax terminal blocks (mars actel
IDC) COMPAX; and Sub-D plug crimping tool, ref: 608868-1 (AMP).
Of course, normal installer's tools are essential: drill, drill bits, soldering iron, cable tie pliers, terminal pliers, etc.
A set of consumables, ref: 9400UXT002 for "one link" is available as an option.
For commissioning, an optional "service kit" (commercial code 9400UXT102) can be used: this can be used to
measure the AGC voltage (relative to the received field) using a DC voltmeter, and includes a
headset/microphone assembly for connecting to the telephone service channel*.
68/314
x For adjusting the polarization of the antenna and the HSB coupler
x For adjusting the polarization of the antenna and the HSB coupler
x For mounting the antenna, the hot standby coupler
x For pointing the antenna
x For adjusting the polarization of the HSB coupler
For mounting the pole mounting for a separate antenna
x For fixing the pole mounting and fine tuning the antenna and vari-
ous fastenings
For fixing the pole mounting and various fastening with the correct
torque
For dismantling/reassembling the cover on classic main, extension
and access IDUs
For fitting integrated attenuators in the ODU
x For fitting the "N" coaxial plugs
x Indoor installations: connectors, software key, handles, or for
changing the polarization of the antenna and for "non integrated"
assembly
For mounting the "pole mounting" in the case of a separate
antenna.
For mounting the solar shield of ODU A9400 flat ODU
Issue 01 -- March 2004
Usage examples
3CC08991ATAA TQ BJA 01
Hide quick links:
Advertisement
Table of Contents
