Advertisement
Important Notes
• The supplied resistance unit needs to be attached to the frame before use.
The unit is very heavy and special care must be taken not to drop the unit. Be especially careful of the
flywheels (one at each end. One chrome, one black) dropping or otherwise hindering the unit will affect the
balance of the unit and void any warranty. Each unit is carefully and fully checked and in full working order
prior to being packaged.
• Adjust the roller pressure to the rear tire properly in order to maximize your tire life.
Tire and roller contact will eventually wear both your tire and the trainer roller.
Wipe the tire surface to remove any solid dust away before setting the bike on the trainer in order to maximize
both the tire and the drive roller life. Minoura recommends adding 10% more air to your tire when training.
• Avoid using your brakes to stop your workout. Let the flywheel come to a stop naturally. Using your brakes
will cause damage to the unit and your tire, possibly causing it to burst.
• For use with a normal 2-wheel bicycle only. Do not use a tandem, recumbent, or other.
Minoura recommends using a completely slick tire when on the trainer. Using a knobby tire will cause
premature wear on the unit and your tire.
• Fits rear wheel hub width between 125 and 140mm.
Hub nut type rear wheel axles are not compatible without replacing the left side coupling bolt (UF-8S) with the
optional Left Side Coupling for Hub Nut Axle (UF-8L).
• To use with the 12mm thru axle rear wheel hub, install the optional "Thru Axle Adapter" on your bike frame.
There are several versions in the adapter depending on the thread pitch size. Choose the appropriate one to
your bike frame.
• The trainer is compatible with tire diameter from 570mm–710mm in Gravity mode and from 610mm–710mm
in Fixed mode. Any other sizes cannot be used.
• Use the supplied rear quick release skewer for maximum stability. The hub clamping parts (couplings) fits the
supplied quick release skewer only. Minoura is not responsible for any problem caused from using your own
skewer.
• Be careful not to pinch your finger when raising up or folding down the resistance unit, or folding the frame.
• Touching the spinning wheel and/or any other moving parts while training may cause serious injury.
Keep children, pets, towel and clothings away from the trainer when in use.
• This product requires electric power souce AC 100 – 240V. Do NOT apply any moisture or mud to the electric
magnet unit. Keep clean and avoid any dust even when using indoors.
If your electric plug shape is different from the supplied one, please use appropriate plug adapter.
• LST9200 has two different resistance systems; the electric magnet and the physical neodymium magnet.
When using the electric magnet as a smart trainer, adjusting the resistance level can be done only by the
wireless control via smart phone or PC. No manual control allowed. Smart phone, tablet, WindowsPC or
Macintosh must be set up separately. Control applications are not included and are available from third party
companies specializing in software applications for SMART trainers.
Neodymium magnet system (non electric) allows LST9200 to be used without electricity and provides basic
resistance for warming up or cooling down.
Please read carefully before use
- 2 -
Advertisement
