Installing A Fan Module - Cisco Catalyst 2350 Installation Manual

Installing a Fan Module

Installing a Fan Module

Use a number-2 Phillips screwdriver to loosen the two captive screws that secure the fan module to the
Step 1
switch chassis.
You should replace the fan module within 2 minutes to avoid overheating the switch.
Caution
Remove the fan module by pulling on the extraction handle.
Step 2
Insert the new fan module into the fan slot, and gently push it in
Step 3
the fan module is flush with the switch rear panel.
Align the two captive screws with the screw holes in the switch rear panel. Using a ratcheting torque
Step 4
screwdriver, torque each screw to 5 lbf-in (80 ozf-in).
Do not reach into a vacant slot or chassis while you install or remove a module or a fan. Exposed
Warning
circuitry could constitute an energy hazard. Statement 206
Figure 3-8
Catalyst 2350 Switch Hardware Installation Guide
3-8
Inserting the Fan Module in Catalyst 2350 Switches
Chapter 3 Power Supply and Fan Module Installation
(Figure
AC OK
PS OK
100 -240
V ~
1.0- 5A
50-6 0 HZ
3-8). When correctly inserted,
OL18479-01