Sony KDL-32L4000 Service Manual page 37

- CLASS 1 LASER PRODUCT -
Do not touch the lens directly with the hands, fingers or skin.
A dirty or smudged lens leads to lower image quality.
When cleaning the product, wipe slowly with a soft, dry cloth.
Ensure the charger is disconnected from the product and that the power is off. Do
not use solvents, alcohol or thinner to wipe the product.
Caution: Potentially hazardous radiation may be emitted from this device.
As with any bright light source, do not stare into the beam, RG2 IEC62471-5:2015.
Use of controls or adjustments or performance of procedures other than those
specified herein may result in exposure to hazardous radiation.
Read the following instructions carefully in order to handle the battery safely.
The battery takes approximately 4 hours to charge and has a standard operating
time of approximately 2 hours.
*Charging time is measured with an authentic charger and cable.
*Battery usage and operating time are based on the battery in its initial state.
When the battery has no charge, the lamp does not light up even if the charger is
connected. Charge for at least a few minutes before using.
Battery life gradually diminishes with repeated use. Once the battery life has
diminished to half that of its original state, replace it with a new battery through the
service center.
Installing the Product
Install the product on a flat, stable surface.
When using the product while connected to a charger, ensure use at an appropriate
distance from the power outlet in order to avoid breaking the connection. Infliction
of shock or impact to the charger or cable could lead to product failure or damage
to the terminal.
Please refrain from using the product in the following places:
Hospitals or near medical equipment that is affected by high wave frequencies
Near cardiac defibrillators or hearing aids
Near many electronic and/or wireless devices (kitchens, cars, aircraft cabins etc.)
37