Table of Contents
Advertisement
Canoga Perkins Corp.
Model L357-1564 V02.00 F19
----------------------------------FUNCTIONAL CONFIGURATION----------------------
Chassis/Slot
User Port Speed/Duplex
Switch Settings:
User Port Speed/Duplex
Side Band Mgmt
LLF Extension to User
LLF User to Extension
1) Configuration Option Control Software
2) User Port Setting
3) Ext Port Setting
4) RMTF
5) Link Loss Echo
6) Link Loss Fwd
Select [1-6]:
------------------------------------Messages------------------------------------
Alarm Outputs: None
Step 7: Cable Connection
Once the changes are made to the modules, the UTP (Unshielded Twisted Pair) or fiber optic
cables can be installed. Remember that the USR port is the port connected to your local/client
device and the EXT port is the port facing the network/trunk. Connect the fiber to the EXT port.
Step 8: IP Address/Subnet Mask/Default Gateway Set-up
From the System Configuration menu, type "5" then "enter" to access the IP/VLAN
Configuration screen. To configure the IP address, select "5," press "enter," and type the IP
address you wish to assign to the unit. Press enter to accept the changes. The Subnet Mask and
Default Gateway must be entered at this point as well.
Canoga Perkins Corporation, 20600 Prairie Street, Chatsworth, CA 91311-6008
Phone: (818) 718-6300, FAX (818) 718-6312 www.canoga.com
P/N 6942590 Rev A
EdgeAccess Ethernet Media Converter
Standalone
Local
Standalone
Link Down
Autonegotiate
Disabled
Disabled
Disabled
100M/Full
1000M/Full
Disabled
Disabled
Disabled
Figure 11. Functional Configuration screen
Figure 12. Fiber optic and UTP cable connection
30-Nov-2005
09:31:28
Remote
Offline
Page 7 of 8
Advertisement
Table of Contents
