Table of Contents
Advertisement
Pin number (on PCB)
1 (SW1)
2 (SW1)
1 (SW1)
2 (SW1)
1 (SW1)
2 (SW1)
1 (SW1)
2 (SW1)
Pin number (on PCB)
3 (SW1)
4 (SW1)
5 (SW2)
6 (SW2)
7 (SW2)
8 (SW2)
Step 3: Module Installation
Several options for installation are available for the L357. For applications requiring multiple
modules in the same location, depending on the size and quantity requirements, the UCS 1000,
UCS 1001 or 1002 chassis may be used. The L357 is also hot-swappable module and it can be
inserted any time without interruption of service to other modules in the chassis.
Chassis or Enclosure
UCS 1000*
UCS 1001
UCS 1002*
UCS 1020
UCS 1030
*Note: Due to power requirements, the maximum number of L357s installable in the chassis
may be different if other modules are installed. Consult Canoga Perkins' Tech Support for
further assistance.
Insert the L357 in an available slot in the 1230 or UCS 1002 making sure that the unit is lined-up
with the card guides. The module should slide into the slot with ease and make contact with the
rear connector without excessive force. Tighten the thumbscrew after insertion. The same steps
apply when installing in the UCS 1020 or 1030. See Figures 2 to 5.
Canoga Perkins Corporation, 20600 Prairie Street, Chatsworth, CA 91311-6008
Phone: (818) 718-6300, FAX (818) 718-6312 www.canoga.com
P/N 6942590 Rev A
UTP port configuration
Function
Autonegotiate
10Mbps
100Mbps
1000Mbps
Table 1. UTP port configuration
UTP and fiber port configuration
Function
User Port Duplex
SideBand Management
Link Loss Forwarding
Extension port to User port
Link Loss Forwarding
User port to Extension port
Not Used
Not Used
Table 2. UTP and fiber port configuration
Maximum number of L357s
19 (AC Power) 21 (DC Power)
Switch position
On (Default)
On (Default)
On
Off
Off
On
Off
Off
On
Off
Full Duplex
Half Duplex
(Default)
Enabled
Disabled (Default)
Enabled
Disabled (Default)
Enabled
Disabled (Default)
N/A
N/A
N/A
N/A
4
9
1
1
Page 2 of 8
Advertisement
Table of Contents
