Table of Contents
Advertisement
O
2/O
Lite Universal Site Interface
MEGA
MEGA
Mounting and Connecting to the O
Refer to System Installation Warnings earlier in this manual before proceeding.
Either version of the O
ensure that it is sturdy enough to support the O
supplied brackets and remove the rubber feet. Then, using appropriate screws and/or
wall anchors, attach the O
POS Connection
Referring to the O
the Network Connection.
•
If connecting to a standard PC – Use a standard NULL-MODEM cable.
•
If connecting to a VeriFone POS system – Referring to the VeriFone
RS232 Adaptor Diagram, which follows, use an RJ45 to DB9 (male)
adaptor to connect to the VeriFone cable.
•
If connecting to other non-PC POS systems – Referring to the RS232 to
O
MEGA
outs.
Dispenser Connection
Referring to the O
Port 3. These are all DB9 (male) connectors which connect directly to a Gilbarco
Universal Data Distribution Box (TW). A standard serial cable, using all nine
wires, may be used to connect the O
three channels, the O
•
Port 1 controls the dispensers on Channel 1.
•
Port 2 controls the dispensers on Channel 2.
•
Port 3 controls the dispensers on Channel 3.
See Start-Up and Configuration in the next section of this manual for information
on logging in to the O
Version 1.0
may be mounted on a shelf or wall. If mounting on a shelf,
MEGA
to the wall.
MEGA
Connecting to the O
Lite Diagram on the next page, connect to Port 4, next to
MEGA
Diagram, which follows, connect using the specified connector pin-
Lite Diagram, which follows, identify Port 1,Port 2 and
MEGA
Lite can control up to 36 dispensers.
MEGA
2 web site to configure the dispensers.
MEGA
Page 3
. If wall mounting, attach the
MEGA
Lite
MEGA
Lite to the Gilbarco DBox. Using all
MEGA
Installation Guide
MEGA
October 2011
Advertisement
Table of Contents
