Table of Contents
Advertisement
O
2/O
Lite Universal Site Interface
MEGA
MEGA
System Installation Warnings
Safety hazards are inherent with all electrical equipment. Standard precautions must
be taken at all times during installation and operation of the O
normal electrical precautions, the following points should be noted during installation.
Installation must comply with National Electrical Code, as well as Federal,
State/Provincial, Local, and all applicable codes.
High voltages are present in the O
which it is attaching. To prevent personal injury or equipment damage,
disconnect all power before proceeding with installation.
O
must be installed in nonvolatile, noncombustible, nonexplosive areas.
MEGA
Typically, this is where the field wiring comes into the building. The box must be
protected from severe vibration, extreme temperatures and excessive humidity.
All O
and associated equipment must be installed in nonhazardous
MEGA
locations and must be UL-listed, using standard communication.
Installation of the O
MEGA
of the National Electrical Code (NFPA 70), the Automotive and Marine Station Code
(NFPA 30A), and all Federal, State, Local, and applicable saf ety codes.
Installation of the all fuel control equipment must comply with the requirements of the
Canadian Electrical Code, the Flammable and Combustible Liquid Code, and all
Federal, Provincial, State, Local, and applicable safety codes.
The installation of the systems covered by this manual in conjunction with equipment
not UL Listed has not been evaluated by the Underwriters Laboratories and is outside
the intended use of this equipment. Warning: All dispensing equipment discussed in
this manual is not UL Listed and the combination has not been evaluated by
Underwriters Laboratories.
Version 1.0
System Installation
MEGA
For Use in USA
and associated equipment must comply with the requirements
For Use in Canada
Page 1
units. In addition to
MEGA
components, as well as the equipment to
Installation Guide
October 2011
Advertisement
Table of Contents
