Mobile Home Requirements; Outside Air - Avalon Astoria Pellet Stove Astoria PS Owner's Manual

Mobile Home Requirements

• Outside air is required (used for
combustion) - see the directions
below.
• The heater must be bolted to the
floor (Some states do not require
this; check with your local building
department). See the illustration
to the right.
• The heater must be grounded to
the steel chassis of the mobile
home (Some states do not require
this; check with your local building
department).
WARNING: DO NOT INSTALL IN
SLEEPING ROOM.
CAUTION: THE STRUCTURAL
INTEGRITY OF THE
MANUFACTURED HOME
FLOOR, WALL, AND
CEILING/ROOF MUST BE
MAINTAINED.
Outside Air (used for combustion)
• Must not be drawn from an enclosed space (garage, unventilated crawl space).
HINT: Travis Industries strongly suggests outside air for all residential installations, especially for
those that are energy efficient, air-tight homes.
• Must not be over 15'
long.
• Must be made with 1 3/4"
diameter or larger metal
or aluminum duct with a
metal screen attached to
the end to keep out
rodents (P.V.C. or other
combustible materials
may not be used). We
recommend the Travis
Industries Outside Air Kit
(part # 99200136).
• Must not terminate above
or within 1' of the
chimney termination.
• Must have a rain cap or
down-turned elbow to
prevent water from
entering.
• Must be located so that it
will not become plugged
by snow or other material.
Travis Industries
Installation
Use the lag bolts (used
to secure the stove to
the pallet) to screw the
pedestal to the floor.
Remove the ash pan
(see page 29).
Air Inlet
(1-3/4"
Outside
Diameter)
1/2"
4050225
b
7/16"
Socket
a
NOTE:
This valve must be open (the rod
Center
parallel with the tube) when the
Line
stove is in operation.
Seal the area around
the tube to prevent
air from entering
through the wall.
10-1/2"
Cut a minimum 2" diameter
hole in the wall.
1-3/4" Diameter Flex Duct
Rain Hood with Rodent Screen
1 1
Select a location
between framing
members for the
outside air hole.
1 0 0 - 0 1 1 5 4