Leds And Buttons On The Top Panel - NETGEAR Nighthawk X6S User Manual

Nighthawk X6S AC3000 Tri-Band WiFi Router Model R7900P

LEDs and Buttons on the Top Panel

The status LEDs and buttons are located on the top of the router.
Table 2. LED and button descriptions
LEDs and Buttons Descriptions
Power Solid amber. The router is starting.
Blinking amber. The firmware is upgrading, or the Reset button was pressed.
Solid white. The router is ready.
Blinking white. The firmware is corrupted.
Off. Power is not supplied to the router.
Internet Solid white. The Internet connection is ready.
Solid amber. The router detected an Ethernet cable connection to the modem.
Off. No Ethernet cable is connected between the router and the modem.
2.4 GHz WiFi Solid white. The 2.4 GHz WiFi radio is operating.
Blinking white. The router is sending or receiving WiFi traffic.
Off. The 2.4 GHz WiFi radio is off.
5 GHz WiFi (2) Solid white. The 5 GHz WiFi radio is operating.
Blinking white. The router is sending or receiving WiFi traffic.
Off. The 5 GHz WiFi radio is off.
USB 3.0 port Solid white. A USB device is connected and is ready.
Blinking white. A USB device is plugged in and is trying to connect.
Off. No USB device is connected, or someone clicked the Safely Remove Hardware button and
it is now safe to remove the attached USB device.
Ethernet ports 1–4 The LED color indicates the speed: white for Gigabit Ethernet connections and amber for 100 Mbps
or 10 Mbps Ethernet connections.
Solid white or solid amber. A powered-on device is connected to the Ethernet port.
Blinking white or blinking amber. The port is sending or receiving traffic.
Off. No device is connected to this Ethernet port.
Hardware Overview of the Router
11