Specifying A Vtep Access Port; Enabling Flood Proxy On Multicast Vxlan Tunnels; Ovsdb Vtep Configuration Examples; Unicast-Mode Vxlan Configuration Example - HPE FlexFabric 7900 Series Vxlan Configuration Manual

Specifying a VTEP access port

For the controller to manage a site-facing interface, you must specify the interface as a VTEP access
port.
To specify a VTEP access port:
Step
1. Enter system view.
2. Enter interface view.
3. Specify the interface as a
VTEP access port.

Enabling flood proxy on multicast VXLAN tunnels

If you use a flood proxy server, you must enable flood proxy globally on multicast tunnels. Then the
multicast tunnels are converted into flood proxy tunnels. The VTEP sends broadcast, multicast, and
unknown unicast traffic for a VXLAN to the flood proxy server through the tunnels. The flood proxy
server then replicates and forwards flood traffic to remote VTEPs.
To enable flood proxy on multicast VXLAN tunnels:
Step
1. Enter system view.
2. Enable flood proxy on
multicast VXLAN tunnels.

OVSDB VTEP configuration examples

Unicast-mode VXLAN configuration example

Network requirements
As shown in
Switch B, and Switch C to provide Layer 2 connectivity for the VMs across the network sites.
Command
system-view
•
•
vtep access port
Command
system-view
vxlan tunnel service node
Figure 18, configure the controller cluster to deploy unicast-mode VXLAN 10 to Switch A,
Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
51
Remarks
N/A
N/A
By default, an interface is not a
VTEP access port.
Remarks
N/A
By default, flood proxy is disabled
on multicast VXLAN tunnels.