lumishore SY 250 Series Installation

SY 220 / SY 250 Light Module Installation Instructions

BEFORE YOU START

This document describes the recommended method for installing the light module of Lumishore SY 220 / SY 250 series lights in order to
provide a water tight seal between the ange (previously welded in) and the light.
• DO NOT use any adhesives, sealants, gaskets, cleaning agents or chemicals other than those speci ed
in this manual. Using any materials in the installation that are not speci ed in this manual will invalidate the
warranty
• The light module is a factory sealed unit. DO NOT attempt to take the light apart or remove any bolts
from the light
• The ange and the light must be electrically isolated - ensure the check described in the manual is
carried out
• The ange / light installation must be pressure checked to ensure it has been installed correctly.
Ensure this check is carried out as speci ed

Parts Supplied

Light Securing Bolt
with Washer and
Insulating Washer
(x7)
Lumishore UK Unit 2, Technium 1, Kings Road, Swansea, SA1 8PH, UK | +44(0)208 144 1694 | Info@Lumishore.com
Lumishore USA 7137 24TH Court East Sarasota, Florida 34243 | (941) 405-3302 | Sales@LumishoreUSA.com
SY 220 / SY 250 Series Underwater lights
INSTALLATION OF A LIGHT MODULE
TO THE WELD-IN FLANGE
(SUPRA AND EOS MODELS)
Please read ALL the following pages before attempting
installation to ensure complete understanding of what is required
SY 220 / SY 250
100 Degree
Light and
Cable
CAUTION
45-0076 - Rev 1
( OR )
SY 220 / SY 250
www.Lumishore.com
60 Degree
Light and
Cable
1