Table of Contents
Advertisement
When Driving
i-ACTIVSENSE
Do not use the Mazda Radar Cruise Control with Stop & Go function (MRCC with Stop &
Go function) system in the following locations, using the Mazda Radar Cruise Control
with Stop & Go function (MRCC with Stop & Go function) system at the following
locations may result in an unexpected accident:
General roads other than highways (Driving under these conditions using the Mazda
Radar Cruise Control with Stop & Go function (MRCC with Stop & Go function) system
is not possible.)
Roads with sharp curves and where vehicle traffi c is heavy and there is insuffi cient
space between vehicles.
Roads where frequent and repetitive acceleration and deceleration occur (Driving
under these conditions using the Mazda Radar Cruise Control with Stop & Go function
(MRCC with Stop & Go function) system is not possible).
When entering and exiting interchanges, service areas, and parking areas of highways
(If you exit a highway while headway control is in use, the vehicle ahead will no longer
be tracked and your vehicle may accelerate to the set speed).
Slippery roads such as ice or snow-bound roads (Tires could spin causing you to lose
vehicle control, or the stop hold control may not operate.)
Long, descending slopes (to maintain distance between vehicles, the system
automatically and continuously applies the brakes which could result in the loss of
brake power.)
Slopes with a steep gradient (The vehicle ahead may not be detected correctly, your
vehicle may slide while stopped by the stop hold control, and it may accelerate
suddenly after it starts moving.)
For safety purposes, switch the Mazda Radar Cruise Control with Stop & Go function
(MRCC with Stop & Go function) system off when it is not being used.
Do not get out of the vehicle while the stop hold control is operating:
Getting out of the vehicle while the stop hold control is operating is dangerous as the
vehicle may move unexpectedly and result in an accident. Before getting out of the
vehicle, switch the Mazda Radar Cruise Control with Stop & Go function (MRCC with Stop
& Go function) system off , shift the selector lever to the P position, and apply the electric
parking brake (EPB).
CAUTION
If your vehicle is towed or you are towing something, switch the Mazda Radar Cruise
Control with Stop & Go function (MRCC with Stop & Go function) system off to prevent a
miss-operation.
4–122
Advertisement
Chapters
Table of Contents
