Air Distribution Valve Assembly - Sandpipper S30 Operating And Servicing Manual

Air Distribution Valve Assembly

(Use with Aluminum Centers ONLY)
Air Distribution Valve Servicing
See repair parts drawing, remove screws.
Step 1: Remove Hex Head Cap Screws (1-F).
Step 2: Remove end cap (1-E).
Step 3: Remove spool part of (1-B) (caution: do not scratch).
Step 4: Press sleeve (1-B) from body (1-A).
Step 5: Inspect O-Ring (1-D) and replace if necessary.
Step 6: Lightly lubricate O-Rings (1-D) on sleeve (1-B).
Step 7: Press sleeve (1-B) into body (1-A).
Step 8: Reassemble in reverse order, starting with step 3.
Note: Sleeve and spool (1-B) set is match ground to a specified clearance
sleeve and spools (1-B) cannot be interchanged.
IMPORTANT
Read these instructions completely, before installation
and start-up. It is the responsibility of the purchaser
to retain this manual for reference. Failure to comply
with the recommendations stated in this manual will
damage the pump, and void factory warranty.
11
• Model S30 Metallic
Air Valve Assembly Parts List
Item Part Number
1 031-173-000
1-A 095-109-157
1-B 031-139-000
1-C 132-029-357
1-D 560-020-360
1-E 165-127-157
1-F 170-032-330
1-G 530-028-550
1-H 165-096-551
1-J 706-026-330
**Air Valve Assembly Parts List
1 031-173-001
Consists of all components above except:
1-F 170-032-115
1-J 706-026-115
**
Note: Pumps equipped with this valve assembly are not ATEX
compliant
sandpiperpump
s30mdl1sm-rev0316
Description Qty
Air Valve Assembly
Body, Air Valve
Sleeve and Spool Set
Bumper
O-Ring
Cap, End
Hex Head Capscrew
1/4-20 x .75
Muffler
Muffler Cap
Machine Screw
Air Valve Assembly
Hex Head Capscrew
1/4-20 x .75
Machine Screw
.
com
1
1
1
2
10
2
8
1
1
4
1
8
4