Switching On And Off; Pairing Process - Midland BT-Intercom Manual

Removing the communication unit from your helmet
• To remove the unit from the clamp press gently your finge against
the arched tip of the back-plate and use the other hand to slide the
headset upwards along the sliding-panel (Picture 5).
Picture 5

Switching on and off

To turn on the headset, hold the CTRL button down for about 6 seconds
until the blue LED flashe three times and an ascending alert tone is
heard. Then release the button.
To turn off the headset, hold the CTRL button down for about 3 seconds
until the red LED flashe three times and a descending alert tone is
heard.

Pairing process

The pairing process allows the units to identify each other.
Pairing the driver/passenger units for Intercom
This process is not normally neaded because the two devices included
in the same packing are already paired and the Intercom function is
already enabled. The pairing process may be needed in case of units
coming from different packaging.
To pair the units:
• Make sure that both unit are turned ON and within a range of one
meter (you can make this procedure with the units detached from
the helmet's clamp)
• Simultaneously press the Intercom buttons of both devices until the
red indicator light of the passenger will light steady
If successful, the red light of the passenger unit will turn to blue light,
steady for some seconds and then flash
If paring has failed, the red light of the passenger will turn off without
change to blue.
Pairing the mobile phone
The driver unit can be paired to a Bluetooth mobile phone in order to
make/receive phone calls.
Follow the procedure below to pair the driver unit to a Bluetooth mobile
phone:
1) Turn on the phone and activate its Bluetooth function.
2) The distance between the headset and the mobile phone must be
within 10 meters.
3) With the unit turned off, press and hold the CTRL button until the
blue and red LEDs begin alternating rapidly.
4) On your phone, search for Bluetooth devices by following your
phone's instructions. Usually this is done by selecting the Search or
Discover option in the Bluetooth or Connection menu.
5) After a few seconds of searching, your phone will list the "Midland-BTI"
as a discovered device. Select it and follow your phone's instructions
to accept pairing.
6) When prompted by your phone, enter 0000 (4 zeros) as your PIN or
passkey.
7) Your phone will confir that pairing has succeeded.
 If pairing is not completed within 2 minutes, the driver unit will return
to stand-by mode (flashin blue every 3 seconds). To pair again,
turn off the driver unit by pressing the CTRL button until the red LED
flashe 3 times and repeat the process as indicated above.
4