Instruction Guide - Midland BT-Intercom Manual

Instruction guide

Thanks for purchasing the Midland BT-Intercom.
In this guide you will fin all the information you may need to get the
best performances from this device.
The package contains:
• two devices, one for the driver, one for the passenger
• 2 clamps for helmet fixin
• 1 wall charger with 2 plugs
• mounting kit: allen wrench, velcro and extension pads.
Device for the driver
The dark blue logo indicates the Bluetooth device for the driver. It allows
the connection with a Bluetooth mobile phone or with the passenger as
an intercom system.
Device for the passenger
It is recognised by the light blue logo. It contains an intercom module
which allows the communication between the driver and passenger.
Attention: this is only a suggestion. The driver device (complete
with both Bluetooth and Intercom modules) can be attached to the
passenger's helmet as well! In that case the passenger will be able to
receive phone calls.
 Make sure both units are fully charged prior to initial use. Allow al
least 4-5 hours for a full charge before using for the firs time.
 The two devices (Driver and Passenger) are ready to be used like
intercom, no pairing process is needed, just fi it on the helmet and
start talking. Only if you need to use the cellular phone (with the
Driver unit), the pairing process is needed (refer to chapter "Pairing
process" for further information).
 The Intercom function uses the AGC technology, that automatically
increases the volume according to the background noise.
Therefore, it may happen that if you try the Midland BT Intercom
inside a silent and close environment, the volume is low but it will
increase while you are on the move on your motorbike!
 If the Driver unit is paired to a cellular phone, just remember that
the "voice recognition answer" to incoming call is enabled by default
(refer to chapter "Voice recognition (VR)" for further information).
Technical specificatio
Technology ............................................................ Bluetooth® ver. 1.2
Maximum distance between driver-passenger .....................about 10m
Battery life in conversation ......................................................about 7h
Battery life in stand-by ................................................. about one week
Charging time ..................................................................... about 4-5h
IMPORTANT
MIDLAND BT-Intercom is a water-resistant device, designed for
safe use under rainy conditions. However, the headset is not
totally waterproof and it is not recommended under heavy rain
conditions.
In any event, the silicone cover protecting the charging jack
should always be tightly closed.
1