Advertisement
ASSEMBLY INSTRUCTIONS
E
Make sure
C
rubber
grippers
are on the
bottom.
Step 1
With rubber grippers on the bottom, place right
B
panel, part (B) on floor with PET GEAR Logo
facing the floor and insert top stair, part (E).
Keep the STRAIGHT EDGE toward the back and
rug facing the top. Make sure there are no gaps
between parts after inserted. (If inserting part
is difficult put a little dish soap on doweled end
before inserting.)
Curved
F
Step 2
Side
Insert riser, part (C).
Make sure there are no gaps between parts
after inserting.
Step 3
B
Insert second stair, part (F). Note the CURVED
SIDE direction. Make sure there are no gaps
between parts after inserting.
Step 4
Insert riser, part (C). Make sure there are no
gaps between parts after inserting.
C
3
EASY STEP IV • PG9740
Advertisement
