Advertisement
Quick Links
Preliminary Users Manual, Electro-Voice Model HTU-2
Wireless Microphone Handheld Transmitter
The component above is part of a Electro-Voice/Telex Wireless Microphone
System. The transmitter is designed to be used in Live Sound Reinforcement
applications where Sound Quality and Reliability are of prime importance.
Simplicity of operation is assured along with flexibility for varying venues.
Operating features and cosmetics are slightly different between Electro-Voice
(Ev) and Telex models but both are electrically identical.
Features:
Handheld Transmitter.....
• 950 Radio Channels, user programmable or factory installed.
• Phase Locked Frequencies for Stable Operation.
• Efficient current drain vs. power system.
• Patented Internal Dipole antenna eliminates wires or "rubber duck"
Antennas.
• Specially shaped Handle for comfort and low handling noise.
• 9 Volt Alkaline battery operation.
• Low Profile Power Switch.
• LCD Display for ease of viewing.
• On-board frequency program and menu "Set"switch.
• Microphone Gain Control.
• Loc-Out control to prevent tampering or accidental changes.
• Permanent "Memory" for frequency/system storage.
• Transmit Tone for squelch control.
• Microphone Gain control for talent set-up.
•
Low Battery Gauge. (read at the receiver).
Advertisement
Summary of Contents for Electro-Voice HTU-2
- Page 1 Preliminary Users Manual, Electro-Voice Model HTU-2 Wireless Microphone Handheld Transmitter The component above is part of a Electro-Voice/Telex Wireless Microphone System. The transmitter is designed to be used in Live Sound Reinforcement applications where Sound Quality and Reliability are of prime importance.
- Page 2 Ev HTU-2/Telex HT-500 Page 2 Specifications: Operating Frequency Range……………..518-608, 614-746 MHz, in 24 MHz wide bands. Frequency Stability……………………… 50 PPM. (18 PPM Euro). Channels…………………………………950 (25 KHz steps). RF Power Output…………………………30 mW (terminated). Antenna……………………………………..1/2 Wave internal. Modulation Type…………………………FM, 40 KHz Deviation.
- Page 3 Ev HTU-2/Telex HT-500 Page 3 Handheld Transmitter set-up: 1. Before setting up the transmitter, please refer to the RE-2/FMR-500 Receiver manual . If the receiver has been set up, continue to step 2. 2. Install a fresh Alkaline Battery into the transmitter.
- Page 4 Ev HTU-2/Telex HT-500 Page 4 APPROVAL INFORMATION The Electro-Voice/Telex Transmitter is Type Accepted under United States Federal Communications Commission CFR 47, Part 74 and Industry Canada RSS123. Licensing of Electro-Voice/Telex equipment is the users responsibility and Licensability depends upon the users classification, users application and frequency selected.