Advertisement
497362_INS_OutdoorWless Spkrs
TRANSMITTER OPERATION
Connecting the Transmitter
The transmitter may be connected two ways depending on your
audio source. If your audio source has left and right RCA output jacks,
you will only use the DUAL RCA CABLE. If your audio source does not
have left and right RCA output jacks, but rather a stereo headphone
jack, you will use both the Y ADAPTER 3.5MM CABLE and the DUAL
RCA CABLE.
Left and Right RCA Output Jacks
1. Insert one end of the TRANSMITTER POWER ADAPTER into DC 9V on
the transmitter, and the other end into an electrical outlet.
2. Insert one end of the DUAL RCA CABLE into the appropriately colored
R/L LINE IN jacks on the transmitter, and the other end into your audio
source's left and right audio output jacks.
Note:
• If there are no fixed-level audio outputs on your audio source,
connect the DUAL RCA CABLE to variable-level (HI-FI) audio
outputs or refer to Headphone Jack for Y ADAPTER 3.5MM CABLE
connection instructions.
• Do not connect the DUAL RCA CABLE to speaker terminals on your TV
or audio source. This may damage the transmitter, your TV or
audio source.
8
4/7/05
12:02 PM
Page 9
FCC INFORMATION
This equipment has been tested and found to comply with the limits
for a class B digital Device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This equipment may not cause harmful interference.
2. This equipment must accept any interference received, including
interference that may cause undesired operation.
5
Advertisement
