Table of Contents
Advertisement
be performed. Use of the power tool for operations
different from those intended could result in a
hazardous situation.
BATTERY TOOL USE AND CARE
Recharge only with the charger specified by the
manufacturer. A charger that is suitable for one type
of battery pack may create a risk of fire when used with
another battery pack.
Use power tools only with specifically designated
battery packs. Use of any other battery packs may
When battery pack is not in use, keep it away from
other metal objects, like paper clips, coins, keys,
nails, screws or other small metal objects that can
make a connection from one terminal to another.
Shorting the battery terminals together may cause
burns or a fire.
Under abusive conditions, liquid may be ejected from
the battery; avoid contact. If contact accidentally
occurs, flush with water. If liquid contacts eyes,
additionally seek medical help.
battery may cause irritation or burns.
SERVICE
Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
SPECIAL SAFETY RULES
Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring. Cutting
accessory contacting a "live" wire may make exposed
metal parts of the power tool "live" and could give the
operator an electric shock.
Protect your lungs. Wear a face or dust mask if the
operation is dusty.
MAINTENANCE
When servicing, use only identical Ryobi replacement
parts. Use of any other parts may create a hazard or
cause product damage.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, and grease.
Do not attempt to modify the product or create
accessories not recommended for use with the product.
2
LED CHARGE INDICATOR
Battery Mode
LED colour
Charging
Green
Flashing
Red (1Hz)
Red
Discharging
Green
Flashing
Green(1Hz)
Flashing
Red (1Hz)
Red
Quick
Flashing
Red (3Hz)
NOTE: The discharging mode refers to a state of operating
with no load. When the product is in a heavy-load condition,
the charge indicator may not be accurate.
BATTERY OVERLOAD PROTECTION
The product is designed to protect the battery from
overloading. When overloading is detected, the product will
automatically switch off. To resume operation, switch the
product off and on again. If the product fails to operate,
it means the battery pack is discharged and should be
recharged in a compatible charger.
Note: There is a thermal protector for the battery cell that
monitors the battery temperature. When high temperature
is detected, the product will automatically switch off and will
not charge. Make sure the temperature goes down before
charging.
KNOW YOUR PRODUCT
See page 5.
1. Saw blade
2. Clamp
3. Strokehead
4. LED light
5. Lock-out button
6. Switch trigger
7.
8. Charge port cover
9. Adaptor
Battery status
Full
Charging
Overheated
>75%
50% - 75%
25% - 50%
<25%
Overloaded
Advertisement
Table of Contents
