Advertisement
2-6
Advanced Configuration
Configure the advanced information.
1
2-7
Confirming Settings
Review the settings that you configured, save and enable them on the switch.
MEMO
The switch has a new IP address after configuration (the IP address of the step 2-5
Your PC still has an IP address which was assigned by the switch during the Express
Setup mode and needs to have an appropriate IP address to reach the new IP address
of the switch. To do so, simply restart your PC.
Click [Enable Telnet].
1
Click [Summary].
2
The SUMMARY window
appears.
2
Click [Submit].
1
The Redirecting pop-up window
appears. Connect the switch to
your network.
1
MEMO
If you want to reconfigure the siwtch, you must return the switch to the factory default
settings. You can reset the switch in the CLI (Command Line Interface). In order to
access to the CLI, the following environments are required.
・
The terminal-emulation program such as Tera Term, PuTTY, Windows Command
Prompt.
・
Connecting the switch and PC directly by the console cable or remotely through
network.
The example below is the commands to reset in case of using Windows Command
Prompt to connect to the switch with Telnet. Bold text indicates commands entered.
C:\Windows\system32>telnet 10.10.10.2
*Enter the username of the step 2-3
Username: cisco
Password: cisco
*Enter the password of the step 2-3
cisco#erase startup-config
Erasing the nvram filesystem will remove all configuration files! Continue? [confirm]
[OK]
Erase of nvram: complete
The example below is the commands to reset in case of connecting to the switch by
the console cable and using Tera Term. Bold text indicates commands entered.
cisco>enable
Password: cisco1234
cisco#erase startup-config
Erasing the nvram filesystem will remove all configuration files! Continue? [confirm]
[OK]
Erase of nvram: complete
When the "Erase of nvram: complete
entering the "reload" command or reconnecting the AC power cord.
).
❷
*Enter the IP address of the step 2-5
❸
❹
*Enter the enable password of the step 2-3
"
message is shown, reboot the switch by
Cisco Catalyst 2960-L Series Easy Setup Guide
2
Configuring Switch
❷
❺
Advertisement
