Hardware Connections - ZyXEL Communications C1000Z Quick Start Manual

Hardware Connections

1 DSL: Use the gray telephone wire to connect your C1000Z's DSL port to
a telephone jack (or to the modem port on a splitter if you are using
one).
2 ETHERNET: Use the yellow Ethernet cable to connect a computer to an
ETHERNET port for initial configuration and/or Internet access.
3 POWER: Use the included power adaptor to connect an appropriate
power source to the POWER socket. Make sure the power source is on.
4 Push in the POWER button.
5 Look at the lights on the front panel.
• The POWER light blinks while your C1000Z starts up and stays on once
it is ready.
• Each ETHERNET light stays on if the corresponding ETHERNET port is
properly connected and blinks when there is traffic.
• The DSL light is on when the C1000Z has a DSL connection.
• The INTERNET light is on when you are able to access the Internet and
blinks when the C1000Z
Is sending or receiving data. Wait a couple of minutes while your device
checks the connection.
If any of these lights are not on, check your connections and inspect
your cables for dam age. If the lights are still off, contact your local
C1000Z Quick Start Guide
4