Pentair HBM 200 series Installation And Service Manual page 11

appropriate ter mi nal blocks in
the control panel.
c. Before connecting power to
the control panel, make sure all
con trol switches (e.g. H-O-A
switch) and protective devices
(e.g. breakers) are in the Off
po si tion. Now connect power
to the terminal block or the
circuit break er as directed by
the sche mat ic.
d. Control panel
grounded properly
NEC and/or local codes. To
facilitate this, a ground lug is
provided on the control panel.
HBM (Pre December 2011)
Terminal Mixer Wire Color
M1 White
M2 Black
M3 Red
G Green
1 Orange Seal Leak Sensor
2 Blue
3 White w/Black Stripe Sensor Common Wire
HBM (Post December 2011)
Terminal Mixer Wire Color
T1 White
T2 Black
T3 Red
G Green
S1 Orange Seal Leak Sensor
H1 Blue
H2 White w/Black Stripe Sensor Common Wire
HBMX (Post December 2011)
Terminal Mixer Wire Color
T1 White
T2 Black
T3 Red
G Green
S1 Red Seal Leak Sensor
S2 Orange Seal Leak Sensor
H1 Black
H2 White/Blue Tracer
must be
per
Mixer Seal Leak and
Heat Sensor Terminals
Function
Mixer Power
Mixer Power
Mixer Power
Ground
Heat Sensor
Function
Mixer Power
Mixer Power
Mixer Power
Ground
Heat Sensor
Function
Mixer Power
Mixer Power
Mixer Power
Ground
Heat Sensor
Heat Sensor
HBM (Pre December 2011)
Mixer Motor
Power Terminals
HBM (Post December 2011)
HBMX (Post December 2011)
Incoming Power
Terminals
Ground
3