Argox iX4 Series User Manual page 48

3 Printer operation Printing a Configuration Report
16. Speed
The speed of printing. The unit is inch per second (ips).
17. Darkness
The current darkness.
18. Print Method
It is either thermal transfer (TT) or direct thermal (DT) printing. TT requires
ribbons and DT doesn't.
19. Print Length
The total print length.
20. Cut Count
It counts the times the cutter cuts.
21. RS232 Protocol
It lists RS-232C settings in the following order: baud rate, data length, parity
check, stop bit and flow control.
22. Code page
The character set table.
23. Media
The media type in use.
24. Calibration mode
There are intelli mode or smart mode.
Intelli mode: Just install labels, latch print module, press FEED button once,
and then the printer will feed 1-2 labels to detect next gap / black mark
before printing. The printer will feed 1-2 labels automatically before printing,
if FEED button is not pressed.
Smart mode: Print from the first label immediately according to label length
setting. Make sure to carefully align label bottom edge at the tear-off
position before printing.
25. Backfeed Enabled/Disabled
Enable or disable backfeed during the printing process. When it is enabled,
the printer moves the paper forward in a predefined length 1 second after
printing, and pulls the paper back in a predefined length once the printing
begins again. When it is disabled, the printer won't move the paper at all.
26. Cutter Enabled/Disabled
43