Setting Method - Sony BVP-E30 Manual

4-2. Setting Method

The RCP assignment function is set from the MSU that becomes Master. Press the menu operation block
[CONFIG] button to display the RCP assignment menu.
For details of the menu operation block and menu operation method, refer to the Operation Manual.
*
Panel Select
Panel Select knob
1. Select the panel that you want to assign, by the Panel Select knob.
2. Select the camera (CCU/HDCU) that you want to operation from the panel, by the Camera Select
knob.
3. When the setting is correct, press [Set] to set the setting. The selection can be cancelled if [Cancel]
is pressed before pressing [Set]. The "*" mark is affi xed to the top of the panel that is changed of its
connection target, by the RCP assignment.
4. To cancel the assignment, press [All|Reset] to display the screen prompting your confi rmation. If
you want to cancel all of the RCP assignment, press [OK]. When [Cancel] is pressed, the screen
returns to the state before [All|Reset] is pressed.
This menu displays only the connected panel and camera normally. If [All|Camera] is pressed, all of the
equipment are displayed up to No. 24. The equipment that was not recognized of its connection is dis-
played with the dark gray background.
By using this function, even the equipment that has turned off the power can become target of the RCP as-
signment.
4-2 (E)
RCP Assignment
Panel No. Camera No.
Panel-01 Camera-01
Panel-02 Camera-02
Panel-03 Camera-03
Panel-04 Camera-04
Panel-05 Camera-05
Panel-06 Camera-06
Panel-07 Camera-07
Panel-08 Camera-08
Panel-09 Camera-09
Panel-10 Camera-10
Panel-11 Camera-11
Panel-12 Camera-12
Camera Select
Camera Select knob
Exit
Set
Cancel
All
Camera
All Reset
Camera Network System